You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
During a long car trip recently I've noticed on three occasions that after the screen waking up to give directions, the car orientation cursor was stuck and not following the correct heading anymore.
The phone was plugged in so no battery optimization were on.
One time the issue fixed itself after a few screen wake ups, other times it needed to restart navigation.
This did not happen in previous versions of Osmand on my phone
Steps to reproduce
Take a car trip with navigation with this screen control settings:
Use system screen timeout > OFF
Timeout after wake-up > 30 seconds
Proximity sensor > ON
Navigation instructions > ON
Power button > OFF
Actual result
Here is a screen recording of the issue. Notice that panning the map so that it is not centered anymore on position fixes the issue momentarily. But the map centered to the position again gets the cursor stuck again. The itinerary line was also not starting on the cursor anymore:
screen-20240915-175316_H.264_2024-09-17.mp4
Expected result
Map cursor follows current heading.
Your Environment (required)
WARNING Crash-Logs MAY contain information you deem sensitive.
Review this CAREFULLY before posting your issue!
OsmAnd Version: 4.9.0
Android/iOS version: android 13
Device model: Sony Xperia 10 III
Crash-Logs: ?
The text was updated successfully, but these errors were encountered:
The bug couldn't be reproduced. To reproduce, configure Screen control with system screen timeout off, timeout after wake-up at 30 seconds, proximity sensor on, navigation instructions on, and power button off. After waking up the screen, the location cursor continued to move along the route as expected.
I have a somewhat similar problem. During navigation, the icon gets stuck about every 1-2 minute, it stops, as if I had stopped the car suddenly. After 5-6 seconds, it suddenly jumps forward to the correct position and continues to move normally.
It is as if there is suddenly no GPS signal, even though there is, the widget also indicates it, and other navigation applications also run normally on the same route.
The screen is always on.
Description
Hi,
During a long car trip recently I've noticed on three occasions that after the screen waking up to give directions, the car orientation cursor was stuck and not following the correct heading anymore.
The phone was plugged in so no battery optimization were on.
One time the issue fixed itself after a few screen wake ups, other times it needed to restart navigation.
This did not happen in previous versions of Osmand on my phone
Steps to reproduce
Take a car trip with navigation with this screen control settings:
Use system screen timeout > OFF
Timeout after wake-up > 30 seconds
Proximity sensor > ON
Navigation instructions > ON
Power button > OFF
Actual result
Here is a screen recording of the issue. Notice that panning the map so that it is not centered anymore on position fixes the issue momentarily. But the map centered to the position again gets the cursor stuck again. The itinerary line was also not starting on the cursor anymore:
screen-20240915-175316_H.264_2024-09-17.mp4
Expected result
Map cursor follows current heading.
Your Environment (required)
WARNING Crash-Logs MAY contain information you deem sensitive.
Review this CAREFULLY before posting your issue!
The text was updated successfully, but these errors were encountered: