Problems with singlecopter mixer

[KioLiex]

No description provided.

[KioLiex]

In the Baseflight GUI the servo outputs are displayed correctly, but all of them are not outputted to a pin. Only the left and right servo are avalible on pin 1 and 2, the motor output is on pin 3. The front and rear servo are not avaliable on any pins.
I have tested in both PPM input mode and normal mode and tried many different combinations of modes, and selection. Nothing can make it work.

[trollcop]

if this worked, servo outputs would be on motor pins 3..6. patches welcome.
it did work before.
On Dec 27, 2014 9:22 AM, "KioLiex" [email protected] wrote:

In the Baseflight GUI the servo outputs are displayed correctly, but all
of them are not outputted to a pin. Only the left and right servo are
avalible on pin 1 and 2, the motor output is on pin 3. The front and rear
servo are not avaliable on any pins.
I have tested in both PPM input mode and normal mode and tried many
different combinations of modes, and selection. Nothing can make it work.

—
Reply to this email directly or view it on GitHub
#231 (comment).

[KioLiex]

Just tried with the stable version from the 1st October. Still Left and right servo on pin 1 and 2. Motor on pin 3. On pin 4-6 the Oscilloscope shows a signal that looks like the one for the motor, but it is at a stable 1ms (1000) in pulse width.
Hope this helps the depugging.

[ChrisKrieg]

I want to give this issue a bump because I am getting the same results as KioLiex. Servo signal is coming through on pins 1 and 2. Pin 6 already burned up one of my servos. It's as if the signals are mapped using the quad with servo gimbal. Sercos on 1 and 2 with motor signals on 4 through 6. This issue pretty much eliminate the possibility of using the singlecopter profile with Baseflight until it is solved.

Does anyone plan on fixing this glitch? I wish I had the coding skills to do it myself, but I must humbly rely on the expertise of others.